Filter
Top Products
7
Assembly
2.1E ASSEMBLY
UNPACKING
Unpack the product where you will be using it. Place the product on a level flat surface. It is recom-
mended that you place a protective covering on your floor. Note: It is recommended that you apply
grease to the threads of each bolt as you assemble the product, to prevent loosening and noise. Also,
during each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in
before completely tightening any ONE bolt.
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY! Place your elliptical
trainer on a level flat surface. It is recommended that you place a protective covering on your floor.
PARTS
• 1 Front Foot Tube
• 2 Upper Handlebars
• 2 Lower Handlebars
• 2 Pedal Link Arms
• 2 Pedal arms
• 2 Guide Rails
• 1 Console
• 1 Console Mast
• 1 Console Mast Boot
• 1 Tension Knob
• 2 AA Batteries
• 2 Foot Pads
• 2 Crank Boots
• 2 Front Upper Handlebar Covers
• 2 Back Upper Handlebar Covers
• 1 Hardware Pack
TOOLS (included)
• 4mm Allen Wrench
• 5mm Allen Wrench/
Phillips Screw Driver
• 13/15mm Flat Wrench
• 17mm Wrench
If you have any questions, or if there are any missing parts, we will guarantee complete satisfaction.
PLEASE CALL OUR TOLL-FREE DIRECT CUSTOMER ASSISTANCE CENTER @ 1-800-244-4192
Mon.-Fri., 8 a.m.-5 p.m. CST (excluding holidays).