ASSEMBLY INSTRUCTIONS
Page 26
HOIST FITNESS SYSTEMS
GENERAL MAINTENANCE INFORMATION
Links, Pull-Pins, Snap Locks, Swivels, Weight Stack Pins:
Upholstery:
Guide Rods:
Decals:
Nuts and Bolts:
Belts and Cables:
F
F
F
F
F
F
F
F
F
F
F
F
F
F
F
Check all pieces for signs of visible wear or damage.
Check springs in snap hooks and pull-pins for proper tension and alignment.
If the spring sticks or has lost its rigidity, replace it immediately.
To ensure prolonged upholstery life and proper hygiene, all upholstered pads should be wiped down with a damp
cloth after every workout.
Periodically take the time to use a mild soap or an approved vinyl upholstery cleaner to deter the onset of cracking or
drying. Avoid using any abrasive cleaners or cleaners not intended for use on vinyl.
Replace ripped or worn upholstery immediately.
Keep sharp or pointed objects clear of all upholstery.
Wipe clean with a clean, dust free rag.
If lubrication is required, lube with or damage to the Top Weight Bearing may occur.
DO NOT repeatedly clean the shafting with alcohol or any other stripping cleanser! The Top Weight Bearing
transfers a gliding material to the guide rods. Cleaning other than wiping with a clean, dust free rag will remove the
previously transferred material and increase the wear to the Bearing Liner.
Inspect and familiarized yourself with any safety warnings or other user information posted on each decal.
nspect all nuts and bolts for any loosening and tighten if needed.
Go through a re-tightening sequence periodically to ensure that all hardware is tensioned properly.
Hoist uses only high quality belts, and mil-spec cables.
Visually inspect the belts and cables for fraying, cracking, peeling or discoloration.
While the machine is not in use, carefully run your fingers along the belt or cable to feel for thinning or bulging
areas.
Replace belts and cables immediately at the first signs of damage or wear. Do not use equipment until belts or cables
have been replaced.
I
Waylube Oil ONLY
F
F
D500
Shoulder Press
Shoulder Shrug