Filter
Top Products
2. IdentifythePivotAxle(14),whichisthelongestaxle.
Slidea RampCover(48)ontoan M6x 16mmPatch
Screw(76)asshown.TightenthePatchScrewinto
oneendofthePivotAxle.Applya smallamountof the
includedgreasetothePivotAxle.
HaveasecondpersonholdthetwoRampSpacers
(99)againstthesidesoftheFrame(1)sotheycover
theindicatedtubesontheFrame.Aligntheround
tubesontheRamp(3)withtheRampSpacers;make
sure that the Ramp is turned as shown in drawing
3 below. Insert the Pivot Axle (14) into the Ramp, the
Ramp Spacers, and the Frame. If necessary, tap the
Pivot Axle with a rubber mallet to insert it.
Slide the other Ramp Cover (48) onto an M6 x 16mm
Patch Screw (76) as shown. Tighten the Patch Screw
into the open end of the Pivot Axle (14).
3. Slide an M6 Washer (64) onto an M6 x 16mm Patch
Screw (76). Tighten the Patch Screw into one end of
the Incline Axle (13). Apply a small amount of grease
to the Incline Axle.
Raise the Ramp (3). Insert the Incline Axle (13) into
the welded tube under one side of the Ramp, through
the motor screw, and then into the welded tube under
the other side of the Ramp. As you insert the Incline
Axle through the motor screw, make sure that the
motor screw does not turn.
Slide an M6 Washer (64) onto an M6 x 16mm Patch
Screw (76). Tighten the Patch Screw into the open
end of the Incline Axle (13).
4. Have another person hold the Upright (2) in the posi-
tion shown. Make sure that the Upright is turned as
shown in drawing 7 on page 8.
Connect the Upper Wire Harness (95) to the Lower
Wire Harness (42). Carefully pull the upper end of
the Upper Wire Harness to remove the slack from
the Wire Harnesses. Slide the Upright (2) onto the
Frame (1). Be careful to avoid disconnecting or
pinching the Wire Harnesses. Attach the Upright with
three M10 x 25mm Button Screws (114) and three
M10 Split Washers (57).
Grease
/
48
76
Grease
64
14
13
99
Tubes
48
6