Filter
Top Products
ASSEMBLY
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included allen wrenches, assembly requires a phillips screwdriver ___ _, two adjustable
wrenches _, a rubber mallet C_7 _ , and pliers
As you assemble the elliptical exerciser, use the drawings below to identify the small parts used for assembly.
The number in parenthesis below each drawing is the key number of the part, from the PART LIST on pages 28
and 29. The number following the key number is the quantity used for assembly. Note: Some small parts may
have been pre-assembled. If a part is not in the parts bag, check to see if it has been pre-assembled.
M6 Washer M8 Washer MI0 Split M8 Nylon Jam M10 Nylon
(64)-2 (66)-2 Washer (57)-3 Nut (86)-6 Locknut (89)---4
/'
Torque Washer
(113)-2
M6 x 16mm Patch
Screw (76)-4
M6 x 48mm Flat
Head Screw (83)-4
M8 x 19mm Patch
Screw (111)-2
M10 x 25mm Button
Screw (114)-3
M8 x 63mm Bolt Set (65)-2
M4 x 16mm Round
Head Screw (96)-1
M4 x 16mm
Screw (98)-4
M10 x 92mm Carriage Bolt (63)-2
M8 x 42mm Button
Bolt (85)-4
M10 x 105mm Carriage Bolt (115)-2
M8 x 35mm Button
Bolt (105)-2
1. Identify the Front Stabilizer (8), which has Wheels (109)
attached to the front. While another person lifts the
front of the Frame (1), attach the Front Stabilizer to the
Frame with two M10 x 92mm Carriage Bolts (63) and
two M10 Nylon Locknuts (89).
While another person lifts the rear of the Frame (1),
attach the Rear Stabilizer (not shown) to the Frame
with two M10 x 105mm Carriage Bolts (not shown)
and two M10 Nylon Locknuts (not shown).
63
109
89
1