Filter
Top Products
6
3. Attach the Right Frame Section (6) to the Right
Upright (2) with a 3/8Ó x 5 1/2Ó Screw (42), a
Plastic Spacer (41), and a 3/8Ó Nylon Locknut
(43). Do not tighten the Nylon Locknut yet.
4. Slide the long end of the Nylon Strap (59) onto
the Right Frame Section (6) as shown. Slide the
short end of the Nylon Strap (59) and the Hip Pad
(28) onto the Left Frame Section (5).
Slide the Left and Right Frame Sections (5, 6)
together. Make sure that the indicated hole is
accessibleÑif necessary, slide the Hip Pad (28) to
the side. Attach the Frame Sections with a #8 x
3/4Ó Screw (23). Do not tighten the Screw yet.
Attach the Left Frame Section (5) to the Left
Upright (1) with a 3/8Ó x 5 1/2Ó Screw (42), a
Plastic Spacer (41), and a 3/8Ó Nylon Locknut
(43).
Tighten all parts used in steps 1, 3, and 4.
Center the Hip Pad (28) on the Left and Right
Frame Sections (5, 6).
Fig. 3
6
2
42
41
43
7
9
3
40
16
60
40
61
Pin
Pin
2. Refer to figure 2b. Slide a Finger Guard (54) onto
the pins on the Left Pivot Bracket (7). Note: The
Finger Guards may already be attached.
Find the Left Link Arm (11), which is labeled with a
ÒleftÓ sticker. Make sure that there is a Bronze
Bushing (16) in each end of the Link Arm. Slide
one end of the Link Arm onto the indicated pin on
the Left Pivot Bracket (7). Slide a 3/8Ó Spacer (60)
onto the same pin. Tap a 3/8Ó Axle Cap (40) onto
the pin. Slide the other end of the Link Arm onto
the pin on the Rocker Arm (9). (Note: It may be
necessary to pivot the Rocker Arm and the Left Leg
[3] slightly.) Slide two 1/2Ó Spacers (61) onto the
same pin. Tap a 3/8Ó Axle Cap (40) onto the pin.
Attach the other Finger Guard and the Right Link
Arm (not shown) in the same manner.
Fig. 2a
11
Fig. 2b
54
7
Pins
16
28
59
59
23
5
42
1
41
43
6
Fig. 4
Hole