Filter
Top Products
Inspect and tighten all parts of the AEROFLYER
regularly. Replace any worn parts immediately. The
AEROFLYER can be cleaned with a soft, damp cloth.
Keep liquids away from the electronic monitor. Keep
the monitor out of direct sunlight or the display may
be damaged. Remove the batteries when storing the
AEROFLYER.
HOW TO FOLD THE AEROFLYER FOR STORAGE
When the AEROFLYER is not in use, it should be
folded to the compact storage position. To fold the
AEROFLYER, first remove the lock knobs and lock
washers from the legs. Insert the lock knobs and lock
washers into the holes in the crossbar. Next, hold the
resistance dials and fold the frame and the uprights
together. CAUTION: When the AEROFLYER is not
in use, always fold it to the storage position and
unbuckle the nylon belt. Place the AEROFLYER in
a location where it cannot fall.
REPLACING THE BATTERIES
If the display of the electronic monitor becomes dim,
or if the monitor does not function properly, the batter-
ies should be replaced. To replace the batteries, refer
to assembly step 6 on page 7.
HOW TO ADJUST THE REED SWITCH
If the speed and distance modes do not display cor-
rect information, the reed switch should be adjusted.
The reed switch is
located below the
electronic monitor
(see the drawing at
the right). Loosen the
screw in the reed
switch, move the reed
switch to the side
slightly, and retighten
the screw. Make sure
that the reed switch
does not hit the
indicated magnet when the AEROFLYER is in use.
Repeat until the speed and distance modes display
correct information.
11
STORAGE AND TROUBLE-SHOOTING
Reed
Switch
Magnet
Frame
Crossbar
Upright
Resistance
Knob
Lock
Knob
Lock
Washer