Filter
Top Products
7
9
25
24
Tab
31
13
36
8
8. Connect the Upper Wire Harness (36) to the Lower
Wire Harness (65). Attach the Upright (13) to the
F
rame (1) with three M8 x 25mm Button Screws (33)
and three M8 Split Washers (59).
Be careful to avoid
p
inching the Wire Harnesses.
65
33
33
33
59
59
1
9. Identify the Left Pedal (24), which is marked with a
“Left” sticker
. Firmly tighten the Left Pedal
counter
-
clockwise
into the left arm of the Crank (31).
Tighten
the Right Pedal (not shown)
clockwise
into the right
arm of the Crank. Important: Tighten both Pedals
as firmly as possible. After using the exercise
cycle for one week, retighten the Pedals. For best
performance, keep the Pedals tightened.
Adjust the Left Pedal Strap (25) to the desired posi-
tion, and press the end of the Left Pedal Strap onto
the tab on the Left Pedal (24). Adjust the Right Pedal
Strap (not shown) in the same way.
10.Make sure that all parts are properly tightened before you use the exercise cycle. Note: Some hardware
may be left over after assembly is completed. Place a mat beneath the exercise cycle to protect the floor.