Filter
Top Products
13
H
OW TO USE THE MANUAL MODE
Insert the key into the console.
See HOW TO TURN ON THE POWER on page
1
2.
Select the manual mode.
When the key is in-
serted, the manual
mode will be selected.
If you have selected a
speed program, rese-
lect the manual mode
by pressing the Program Select button repeatedly
until only zeros appear in the displays.
Start the walking belt.
To start the walking belt, press the Start button,
the Speed increase button, or one of the num-
bered speed buttons.
If you press the Start button or the Speed in-
crease button, the walking belt will begin to move
at 1 mph. As you exercise, change the speed of
the walking belt as desired by pressing the Speed
increase and decrease buttons. Each time you
press a button, the speed setting will change by
0.1 mph; if you hold down a button, the speed set-
ting will change in increments of 0.5 mph. Note:
After you press the buttons, it may take a moment
for the walking belt to reach the selected speed set-
ting.
If one of the numbered speed buttons is pressed,
the walking belt will gradually change speed until it
reaches the selected speed setting.
To stop the walking belt, press the Stop button.
The time will begin to flash in one of the displays.
To restart the walking belt, press the Start button or
the Speed increase button.
Change the incline of the treadmill as desired.
To change the incline of the treadmill, hold down
the Incline increase or decrease button until the
desired incline level is reached.
Follow your progress with the track and the
displays.
The track—The track
represents a distance of
1
/4 mile (400 meters).
As you walk or run on
the treadmill, the indica-
tors around the track will
appear in succession until the entire track ap-
pears. The track will then disappear and the indi-
cators will again begin to appear in succession.
The center of the track will show the number of
laps that you have completed.
The lower left
display
—As you exer-
cise, the lower left dis-
play can show the
elapsed time and the
distance that you have
walked or run.
The lower right
display—The lower right
display can show the
speed of the walking belt
and the approximate
number of calories that
you have burned. The display also shows your
heart rate when you use the pulse sensor (see
step 6 on page 14).
The upper display—
The upper display can
show the elapsed time,
the distance that you
have walked or run, the
speed of the walking
belt, or the approximate number of calories you
have burned. Press the Priority Display button re-
peatedly until the upper display shows the informa-
tion that you are most interested in viewing. Note:
While information is shown in the upper display,
the same information will not be shown in the
lower left or lower right display.
To reset the displays,
press the Stop button, re
-
move
the key, and then reinsert the key.
5
4
3
2
1