Filter
Top Products
13. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key
in a secure place. The hex key is used to adjust the walking belt (see page 19). To protect the floor or carpet,
place a mat under the treadmill.
11. See the lower drawing. Position the Uprights
(53, 54) so that the treadmill Frame (51) is cen-
tered between the Uprights.
Firmly tighten the two Colored Patch Frame
Bolts (1) and the four Upright Bolts (2).
Be care-
ful not to overtighten the Colored Patch
Frame Bolts.
11
2
51
1
53
51
54
Top View
12. Attach the Latch Housing (48) to the Left
Upright (53) with two Latch Screws (10); start
both Latch Screws before tightening them.
Make sure that the large hole in the Latch
Housing is on the indicated side.
Remove the knob from the pin. Make sure that
the collar and the spring are on the pin. (Note: If
there are two collars, place one on each side of
the spring.) Insert the pin into the Latch Housing
(48). Then, tighten the knob onto the pin.
Plug in the power cord (see OPERATION
AND
ADJUSTMENT on page 11).
Next, change the
incline of the treadmill to the lowest level as
described on page 13. If this is not done, the
latch may not hold the treadmill in the stor
-
age position.
10
Pin
Spring
Collar
Knob
48
53
Large Hole
11
10. Attach the ground wire on the Wire Harness (39)
to the indicated hole in the Base (52) with a
G
round Screw (84).
52
39
G
round Wire
1
0
84
Hole
10