Filter
Top Products
3.
Figure 23
Figure 24.
4.
Steps 5-9
Hold the motor housing when tilting. Do
not hold the drawbar cap. If you do, the cap
can come off and the headstock can swing
down uncontrollably, causing severe per-
sonal injury or machine damage.
Headstock Tilting
Figure 22
NOTICE
This mill is designed to operate with a right-
left headstock tilt of 45 To prevent head-
stock binding and insufficient support, do
not tilt the headstock to a full 90. Binding
occurs when one of the hex bolts on the
side of the headstock (Figures 23–24) binds
in the T-slot.
Figure 22.
Tools Needed Qty
To tilt the head:
1.
2.
Figures 23–24