Filter
Top Products
8
11
12
13
13. Press a 38mm x 50mm Inner Cap (64) into the
indicated part of the Sliding Seat Frame (15).
Press two 75mm Bushings (26) into the ends of
the Sliding Seat Frame.
Orient the Sliding Seat Frame (15) as shown. Pull
the Knob (not shown) out as far as it will go. Slide
the Sliding Seat Frame onto the Bench Frame
(14) and engage the Knob into an adjustment
hole in the Bench Frame.
Press a 60mm Square Angled Inner Cap (95) into
the end of the Bench Frame (14).
10
77
79
79
46
70
70
26
26
95
15
14
64
Knob
14
18
51
51
77
74
39
52
78
77
79
79
8
Top
40
Decal
5
10. Orient the Pull-up Bar (8) with the bend on top.
Attach the Pull-up Bar to the Right Frame (5) with
two M10 x 57mm Bolts (78), two M10 Washers
(79), and two M10 Nylon Locknuts (77). Do not
tighten the Locknuts yet.
Attach the Pull-up Bar (8) to the Left Frame
(not shown) in the same manner.
Tighten the M10 Nylon Locknuts (77) used in
steps 1–10.
11. Press two 38mm x 50mm Angled Inner Caps (52)
into the top of the Back Leg (39). Press two
50mm Square Inner Caps (51) into the ends of
the Stabilizer (40).
Orient the Stabilizer (40) so the decal is in the
position shown. Attach the Back Leg (39) to the
Stabilizer with two M10 x 62mm Carriage Bolts
(74) and two M10 Nylon Locknuts (77). Do not
tighten the Locknuts yet.
12. Press a 60mm Square Inner Cap (46) into the top
of the Front Leg (18).
Orient the Bench Frame (14) as shown. Attach
the Bench Frame to the Front Leg (18) with two
M10 x 78mm Bolts (70), two M10 Washers (79),
and two M10 Nylon Locknuts (77). Do not tight-
en the Locknuts yet.