Filter
Top Products
10
18
18. Press two 38mm Square Inner Caps (44) into the
ends of the Seat Frame (17).
Orient the Seat (37) with the wide end on the side
shown. Attach the Seat to the Seat Frame (17)
with four M6 x 16mm Screws (72).
37
Wide End
72
72
17
44
44
19
19. Lubricate an M10 x 154mm Bolt (69) with grease.
Attach the Seat Frame (17) to the Backrest
Frame (16) with the Bolt, two M10 Washers (79),
and an M10 Nylon Locknut (77). Do not over-
tighten the Nylon Locknut; the Seat Frame
must be able to pivot easily.
20. Attach the Right and Left Power Assist Legs (20,
21) to the Leg Lever (19) with two M10 x 100mm
Bolts (66) and two M10 Nylon Locknuts (77).
21. Refer to the CABLE DIAGRAMS on page 19 of
this manual to identify the different cables
included with the weight bench.
Locate the Bench Cable (58). Route the Cable
through the Front Leg (18) and attach it to the
Leg Lever (19) with an M10 x 91mm Bolt (67),
two 35mm Spacers (82), two M10 Washers (79),
and an M10 Nylon Locknut (77).
Press a 2” x 3” Inner Cap (50) into the bottom of
the Leg Lever (19).
69
20
21
77
79
79
18
67
82
82
50
19
58
66
20
19
16
77
79
79
17
Lubricate
77
21