Filter
Top Products
8
6. Attach the Bench Frame (3) to the Center Frame
(4) with two M10 x 80mm Button Bolts (54), an
M10 x 90mm Hex Bolt (19), a Small Support
Plate (21), and three M10 Nylon Locknuts (66).
Tighten the M10 Nylon Locknuts (66) used in
steps 2–6.
21
19
54
6
66
66
66
4
3
4. Attach the Front Leg Bumper (40) to the Front Leg
(9) with an M4 x 16mm Screw (58).
5. Orient the Seat Carriage (22) and the Bench
Frame (3) as shown. Pull the Knob (43) and slide
the Seat Carriage onto the Bench Frame.
Engage
the Knob into a hole in the Bench Frame.
Attach the Bench Frame (3) to the Front Leg (9)
with two M10 x 75mm Hex Bolts (57), two M10
W
ashers (64), and two M10 Nylon Locknuts (66).
Make sure that the Nylon Locknuts are inside
the hexagonal holes in the bottom of the
Bench Frame. Do not tighten the Nylon
Locknuts yet.
4
58
40
9
3
43
57
22
66
Hexagonal
Holes
64
64
9
5