Filter
Top Products
10
10. Grease the outside of the barrel of an M10 x
70mm Bolt Set (59). Attach the Leg Lever (10) to
t
he Front Leg (9) with the Bolt Set. D
o not over-
tighten the Bolt Set; the Leg Lever must pivot
e
asily.
11. Insert the Long Pad Tube (28) into the Front Leg
(9). Slide two Round Pads (17) with Pad Covers
(39) onto the Long Pad Tube. Then, press two
Pad Caps (38) into the Long Pad Tube.
Assemble the two Short Pad Tubes (18) to the
Leg Lever (10) in the same way.
12. Attach a Long Pin (32) to a Safety Spotter (6)
with an M4 x 16mm Screw (58). Next, attach a
Long Pin (32) to a Weight Rest (7) with an M4 x
16mm Screw (58).
Slide the Safety Spotter (6) onto an Upright (5) as
shown. Insert the Long Pin (32) into the Safety
Spotter and a hole in the Upright.
Next, slide the
W
eight Rest (7) onto the Upright. Insert the Long
Pin (32) into the Weight Rest and a hole in the
Upright.
Make sure that the heads of the Long
Pins are on the outside of the weight bench.
Repeat this step on the other side of the
weight bench. Always set both Safety Spotters
(6) and both Weight Rests (7) at the same
height.
59
1
0
59
9
10
11
12
17
28
10
9
7
6
58
32
58
32
18
18
39
38
38
39
17
Grease
5