Filter
Top Products
(3) Re-engage the brake quick-release mechanism to restore correct brake pad-to-rim clearance; spin the wheel to make sure that it is centered
in the frame and clears the brake pads; then squeeze the brake lever and make sure that the brakes are operating correctly.
c. Removing a Bolt-On Rear Wheel with Hand Brake
WARNING: If your bike is equipped with an internal gear rear hub, do not attempt to remove the rear wheel. The removal and re-
installation of internal gear hubs require special knowledge. Incorrect removal or assembly can result in hub failure, which can cause you to
lose control and fall.
(1) If your bike has rim brakes, disengage the brake’s quick-release mechanism to open the clearance between the wheel rim and the brake pads
(see Section 4.C, figs. E through I).
2) Shift the rear derailleur to high gear (the smallest rear sprocket) and pull the derailleur body back with your right hand.
(3) Using the correct size wrench, loosen the two axle nuts.
(4) Lift the rear wheel off the ground a few inches and, with the derailleur still pulled back, push the wheel forward and down until it comes
out of the rear dropouts.
d. Installing a Bolt-On Rear Wheel with Hand Brake
(1) Shift the rear derailleur to its outermost position and pull the derailleur body back with your right hand.
(2) Put the chain on to the smallest sprocket. Then, insert the wheel into the frame dropouts and pull it all the way in to the dropouts. The
axle nut washers should be on the outside, between the frame and the axle nut.
(3) Using the correct size wrench, tighten the axle nuts as tightly as you can.
(4) Push the rear derailleur back into position.
(5) Re-engage the brake quick-release mechanism to restore correct brake pad-to-rim clearance; spin the wheel to make sure that it is centered
in the frame and clears the brake pads; then squeeze the brake lever and make sure that the brakes are operating correctly.
e. Removing a Bolt-On Rear Wheel with Coaster Brake
WARNING: If your bike is equipped with an internal gear rear hub, do not attempt to remove the rear wheel. The removal and re-
installation of internal gear hubs require special knowledge. Incorrect removal or assembly can result in hub failure, which can cause you to
lose control and fall.
(1) Disengage the coaster brake arm from its frame bracket.
22