Filter
Top Products
6
• If the lever comes off, simply re-attach it.
• Insert the peg on one side of the lever into the hole in
the collar.
• Snap the other peg in the lever into the other hole in
the collar.
Assembly is now complete.
Please refer to assembly step 2 to fill the base with
water or approximately 50 lbs. (22.7 kg) of sand (water
and sand not included) to keep this product stationary.
Holes
Peg
Peg
Assembly
• This toy includes an inflatable ball. If the ball becomes
soft, inflate it with a standard, manual air pump with a
standard air needle.
• The ball will contain the correct amount of air when its
circumference measures about 21-22 inches (53-56 cm).
Measure the circumference of the ball with a tape mea-
sure or with a piece of string cut 21-22 inches (53-56 cm)
long. Do not over-inflate the ball.
• To clean, use a clean, damp cloth. Be sure to remove
soap residue.
• Do not immerse this product.
• Do not leave this toy outside in freezing weather. Water left
inside the base will freeze and possibly damage the base.
• Check all fasteners regularly to be sure they are tight. If
the fasteners are not tight, tighten them as necessary.
• Check plastic parts regularly and if broken or cracked, dis-
pose of them properly.
• We recommend indoor storage if this product will not be
used for an extended period of time.
Care and Maintenance
13