Filter
Top Products
EVO2 MOTORIZED TREADMILL
Visit us at: www.evofitness.com
25
MOTION CONTROL OPERATION
MOTION CONTROL:
1. Press the button on the console to switch the motion control
function on and off:
• When the LED light is ON the MOTION CONTROL is active.
• When the LED light is OFF the MOTION CONTROL is off.
2. After switching on the MOTION CONTROL wave your right hand
approximately 6 inches above the motion sensor on the right handle bar
to increase the speed. The sensor will sound one short BEEP per scan
and speed up by 0.1 MPH per BEEP. Holding your right hand
approximately 6 inches above the right sensor constantly results in the
sensor sounding one long BEEP per second and speeding up by 0.5
MPH per BEEP.
2. Use right sensor to speed up.
3. Wave you left hand approximately 6 inches above the motion sensor on
the left handle bar to decrease the speed. The sensor will sound one
short BEEP per scan and decrease speed by 0.1 MPH. Holding your left
hand approximately 6 inches above the left sensor constantly results in
the sensor sounding one long BEEP per second and decreasing speed
by 0.1 MPH per BEEP.
3. Use left sensor to slow down.
4. Wave both hands approximately 6 inches above both motion sensors at
the same time. The sensor will sound two short BEEPs then stop the
belt.
• Always switch off the MOTION CONTROL function by pressing the
button before turning off the power to the treadmill.
4. Use both sensors to stop belt.