Filter
Top Products
LISTENING TO FM, AM OR SW1-10
E1100 OPERATION MANUAL
4
Remove the battery compartment cover by pushing it in the direction
of the arrow. Install two ‘AA’ batteries according to the polarity sym-
bols (+ and -) marked next to the compartment. For easy removal,
place the batteries on top of the lift-out ribbon.
Turn the radio on with the POWER/SLEEP button, on the right side of
the radio.A quick, short press engages the sleep timer with 60 min-
utes of playtime and the sleep timer symbol appears in the upper
right corner of the display.To select a different time,press the
POWER/SLEEP button immediately after the radio turns on, selecting
60, 45, 30, 15, 10, 05, 120, 90 or 75 minutes.
To defeat the sleep timer, turn on the radio by pressing the
POWER/SLEEP for about two seconds.To turn it off, press the
POWER/SLEEP button.
It’s normal for the display to become lit for about 5 seconds,every
time that a button is pressed, except with the RADIO/BUZZER button,
on the right side of the radio.
Use the volume knob, on the left side, to adjust the volume.
BATTERIES
Select the FM,AM or SW1-10 band by using the band selector
switch.AM is shown as MW. Use the TUNE knob to tune the radio to
the desired frequency. If you are using an earphone to listen to FM-
stereo, the FM-stereo LED will light in the upper left corner. Note that
the frequency of the station appears in the display.
Shortwave allows listening to stations from around the world. During
the day, listen above 13 mHz.At night, listen below 13 mHz. To learn
more use the Internet or the two books below:
PASSPORTTOWORLD BAND RADIO Published by International
Broadcasting Services (IBS); IBS NorthAmerica, Box 300, Penn’s
Park PA 18943. Phone: (215) 598-9018. www.passband.com.
WORLD RADIO TV HANDBOOK Published in the USA by
Watson-Guptill Publications, 770 Broadway,7th Floor,New York,
NY 10003-9595. www.watsonguptill.com.
ForAM (MW) the radio uses an internal, directional, ferrite bar anten-
na. Rotate the radio for best reception.
For FM/SW,fully extend the telescopic antenna.
The E1100 can be used with anAC adaptor that supplies an output
of 3 volts DC, negative polarity, 100 milliamperes or greater current.
To purchase this, visit www.etoncorp.com.
POWER ON/OFF AND SLEEP TIMER
VOLUME
LISTENING TO SHORTWAVE
ANTENNA
5
AC ADAPTOR (INCLUDED)