Filter
Top Products
7372
<Resetting procedure>
1. Pull the crown out to position 1 and turn to align
the mode hand with CHR (chronograph mode).
2. Pull out the crown to position 2.
• The hands will rotate rapidly.
3. After the hands stop, press buttons (A) and (B) at
the same time.
• When you remove your finger from the buttons,
all parts of the digital displays and the lights will
come on.
• The confirmation tone sounds, the hands move
clockwise and counterclockwise and the watch switches to the reference position checking
status.
4. If the reference position is incorrect, correct it.
(Refer to “Checking the Reference Position” (p. 14) and “Adjusting the Reference Position”
(p. 74).)
All parts displayed
[Digital display 2] [Digital display 1]
WW
21. LED Lights
• Press the upper right button (B) while the crown is in the normal position to turn on the LED lights of
digital displays 1 and 2 for three seconds. However, note that the lights do not come on in the
following cases.
* During timer mode or chronograph mode
* During radio wave reception
* During 2-second interval movement (insufficient charge warning status)
WW
22. Resetting Your Watch
• If the watch displays or operates abnormally due to a strong impact or the effects of static electricity,
reset the watch and then correct the reference position.
[Caution] After resetting, all the mode settings return to their initial settings. Perform the settings
again as required.
<Initial settings after resetting>
• Home city/world city: UTC • Time: 0:00:00
• Date: January 1, 2008 (Tuesday) • Timer: 99 minutes 00 seconds
• Chronograph: 0 hours 00 minutes 00 seconds (reset status)
• World time: City displays - all SET, daylight saving time - all OF (off)
• Alarm 1/2: City - UTC, time - 12:00, set - OF (off)
• Receive set: Daylight saving time - AU, automatic reception - AUT