Filter
Top Products
7170
4. Press the upper right button (B) to enter the automatic reception setting status.
• The set automatic reception status flashes.
• AUT, MAN and OFF flash and the watch enters the correction status.
5. Press the lower right button (A) to set the automatic reception operating condition to
MAN.
• The hour of the reception time flashes.
• Each time the lower right button (A) is pressed, the correction location changes in
the following sequence: AUT c MAN c OFF.
6. To change the reception time, turn the crown to change the time in 1-hour units.
• Turn the crown to the right to move the time forward and to the left to move the time
back.
• Only the 4 a.m. automatic reception can be changed. (2 a.m. and 3 a.m. are not
displayed.)
• Only the hour can be changed, and when using the 12-hour clock, “A” indicates a.m.
and “P” indicates p.m.
7. Press the crown back into its normal position.
* Nighttime is usually a good time for reception because radio wave noise is relatively
low.
<Setting procedure>
1. Pull the crown out to position 1 and turn to align the mode hand with RX-S (receive
set mode).
2. Pull the crown out to position 2 to enter the daylight saving time (SMT) reception
setting status.
• AU or mA flashes and the watch enters the correction status.
• Each time the upper right button (B) is pressed, the display switches between the
daylight saving time reception setting and the automatic reception setting.
3. Press the lower right button (A) to select AU or mA.
[Daylight saving time
reception setting]
Button (A) Button (B)
Button
(A)
Button
(A)
Turn the crown
Button (A)
[Automatic reception setting]