Filter
Top Products
Operation Guide 4782 (OC)
6
Use the
CC
CC
C button to enter the Alarm Mode as
shown under “Modes and Indicators”.
The watch beeps for 10 seconds when the current time in the
Timekeeping Mode reaches the alarm time you set. There are three
independent alarms, and all of them operate the same way. The
Hourly Time signal causes the watch to beep every hour on the hour.
❚
To select an alarm or the Hourly Time
Signal screen
Each press of the D button cycles through available screens in the
sequence shown below.
Alarm 1 Alarm 2
Alarm 3Hourly Time Signal
3. Use the
DD
DD
D (+) and
BB
BB
B (–)
buttons to change the
hour setting.
• In this example, use D (+)
and B (–) to set the hour to
3:00 p.m.
• Holding down either button
changes the setting at high
speed.
• When setting the hour, make
sure you specify AM (no
indicator) or PM (P) correctly
when using 12-hour
timekeeping, or that you
specify the correct 24-hour
time.
4. Press the
CC
CC
C button to
select the minute setting.
• This causes the minute digits
to flash.
(–)
(+)
❚
To set an alarm time
Example: To set Alarm 2 for 3:30 p.m.
1. In the Alarm Mode, use the
DD
DD
D button to scroll
through the alarm screens
until the one whose
setting you want to
configure is displayed.
2. Hold down the
AA
AA
A button
for about two seconds
until the hour digits start
to flash.
• This is the setting screen.
• Displaying the setting screen
turns on the alarm
automatically.
Alarm Number
(+)
Hour
Minute
❚
To turning an alarm or the hourly time
signal on and off
1. In the Alarm Mode, use the
DD
DD
D button to display the
screen for the alarm you
want to turn on or off.
• Each press of the D button
advances to the next alarm,
which is indicated by the
alarm number on the display.
2. Press the
AA
AA
A button to toggle the displayed alarm on
(ON) or off (OFF).
Alarm 2 Screen
Hourly Time Signal Screen
❚
To stop the alarm
Press any button.
❚
To test the alarm
In the Alarm Mode, hold down the D button to sound the alarm.
Alarm Number
(+)
5. Use the
DD
DD
D (+) and
BB
BB
B (–)
buttons to change the
minute setting.
• Each press of the D (+) and
B (–) button changes the
minute setting in 30-minute
increments.
• Holding down either button
changes the setting at high
speed.
6. When the setting is the way you want, press the
AA
AA
A
button to exit the setting screen.
• The setting screen also will be exited automatically if you do
not perform any operation for about two or three minutes.
(–)
(+)
Using the Alarm and Hourly Time Signal