Filter
Top Products
163
Appendix
The time and date
settings configured
the first time after
purchasing the
camera are reset to
their factory
defaults when
remove the
camera’s battery.
Load the camera’s battery and reconfigure the time and date
settings (page 19). Do not remove the battery from the camera
for at least 24 hours after configuring time and date settings.
After that, the settings will not be reset if you remove the
battery.
• If the time and date are reset to their factory default settings
when you remove the battery after it has been loaded for
more than 24 hours, it could mean that the camera’s setting
memory is defective. Contact your retailer or a CASIO
authorized service center.
Buttons are not
responsive right
after the power has
been turned on.
With large capacity memory cards there is a delay after the
power has been turned on before the buttons become
responsive.
Display Messages
ALERT
The camera’s protection function may have activated
because camera temperature is too high. Turn off the
camera and wait until it cools down before trying to use it
again.
Battery is low. Battery power is low.
Cannot correct
image!
Keystone correction of the image cannot be performed for
some reason. The image will be stored as-is, without
correction (page 62).
Cannot find the
file.
The image you specified with the slideshow “Images” setting
cannot be found. Change the “Images” setting (page 91) and
try again.
Cannot register
any more files.
You are attempting to save a user BEST SHOT scene in the
“SCENE” folder when the folder already contains 999 user
scenes (page 60).
Card ERROR
There is something wrong with the memory card. Turn off the
camera, remove the memory card and then reload it into the
camera. If this message re-appears when you turn the
camera back on, format the memory card (page 143).
IMPORTANT!
• Formatting a memory card deletes all its files. Before
formatting, try transferring recoverable files to a computer
or some other storage device.
Problem Possible Cause and Recommended Action