Filter
Top Products
4
SETUP AND OPERATION
WARNING: Insure the weapon is unloaded and the safety selector is in the
”safe” position before attempting to install, remove or perform maintenance
on the sight.
Installing the Battery
a) Remove Battery Cap by turning it counter clockwise.
b) Insert a battery (type CR2032) with positive (+) end toward Cap.
c) Install Battery Cap by turning clockwise until snug. Hand tighten only,
using a coin or similar item. Using tools could damage the equipment.
Note: (not necessary when the sight is new) Before installing the Battery Cap
(2), inspect that the O-ring is present and not damaged. Failure to do so could
result in water leakage into the battery compartment.
d) Verify that red dot is present by turning the Rotary Switch clockwise.
Installing the Sight on the Firearm
The Micro Sight is designed for installation on most types of weapons, which
have a MIL-Std 1913 Picatinny Rail or Weaver Rail. If your weapon does not
have or support an appropriate base(s), please consult your dealer, gunsmith
or other qualied source.
Installing the Sight on a Picatinny/Weaver Rail
a) Loosen the Shaft by means of the Allen Wrench, so that the Locking Bar
(12) can clamp around the Picatinny/ Weaver Rail.
b) Install the Sight to the weapon Rail by tightening the Shaft). First, ensure
that the Sight is correctly positioned and that the Shaft (=recoil stop) ts
into a groove on the Picatinny/Weaver Rail.
To make sure that the Shaft is rmly tightened, screw the Shaft clockwise
until a light resistance can be encountered.
After that, screw another 1/4 to 1/2 turn. WARNING! Do not overtighten.
c) When using Lens Covers, ensure that they are correctly positioned and
can easily be opened.
d) Finally, make sure that the Shaft with Locking Bar is rmly tightened
around the weapon Rail.
e) Complete zeroing according to the "Zeroing" section below.
Lens Covers
In order to preclude the loss of the lens covers when removed from the
optical path of the Sight, the lens covers should be removed downwards.
The rubber string will then grab around the Sight and Base.