Filter
Top Products
9
Fig. 5
Fig. 6 Fig. 7
Fig. 8
Fig. 9
Fig. 10
5) Utilizing the 1.5mm Allen wrench, re-tighten the zero stop set screws inside the black inner locking cap (Fig. 7). The screws should
be tightened until you feel them seat and then an additional ¼ revolution (approximately 1.5-2 inch pounds). Do not over-tighten as
this will cause damage to the screws.
6) Replace the turret knob on to the turret by aligning the splines in the turret cap and the turret and orient your turret to “O” position
and seat the cap (Fig. 8 & 9). Once the cap is properly seated insure that the rubber o-ring is in place then replace cap screw and tighten,
finger tight with a coin or until snug with a screw driver (Fig. 10).
7) Your zero stop is now set.
SETTING A ZERO STOP (Z-Stop™ Models Only)