Filter
Top Products
7
Special Note: SCOPES EQUIPPED WITH THE Z-LOK™ ELEVATION TURRET
If your scope is equipped with the Z-Lok zero stop elevation turret, the scope’s windage and elevation controls are positioned in the
center of their travel at the factory. This will allow a minimum of 15 mils (or 50 moa) of reticle travel in the up or down direction on the
elevation turret. The zero stop is not set at the factory, and will not interfere with reticle travel in the up or down direction. Use of the
zero stop is optional and the scope will operate normally with the Z-Lok remaining at the original factory set position.
If you decide not to use the Z-Lok, after zeroing your weapon please refer back to the instructions on page 6, which will help you to
re-index your turret(s) to the zero position.
If you would like to engage the Z-Lok after zeroing your weapon please proceed to the next section.