Filter
Top Products
6
Setup
1. Open the battery cover located on the bottom of the Viewer by sliding it the direction of the arrow on
the cover, and insert two AA size batteries (alkaline, lithium or NiMh) with the at end (negative, or “-”
terminal) of each battery in contact with the springs. Slide the cover back to the closed position. The small
holes on the back of the Viewer, just below the battery cover, allow sound from the speaker to be heard
during playback of video clips that may also contain audio.
2. Slide open the door on the left side of the Viewer in the direction of the arrow on the door. Insert an SD
or CF card* into the correct size slot (do not attempt to insert an SD card into the CF card slot). With the
slots oriented as shown in the Parts Guide, (lettering upright, USB on right), SD cards should be inserted
“face down” (metal contacts on card facing up, notched corner on rear left). To insert, push the SD card in
until a click is heard. To remove, push in again, then pull out. CF cards simply push in/pull out (face up).
Use the “Camera” slots (A) for cards from your Trail Camera. Use the “Storage” slot (B) for a blank SD
card (optional) if you will want to copy photos from a card in one of the “Camera” slots. After inserting
your card(s), briey press the Power switch on the lower right side of the Viewer. The screen will activate
in a few seconds (the time it takes may vary with the number and size of the les on your card) and display
the rst image on your camera card. To turn off the Viewer when you are done, press the Power button
again. Replace the door (cards may be left in place) that covers the slots and USB port when not using or
carrying your Viewer, to prevent the entry of dust and dirt.
3. Please refer to the section titled “Setup Options” for details on how to change the language used for all
display menus and change the Auto Off interval if desired.
* Secure Digital or Compact Flash