Filter
Top Products
4
1) The camera is powered by two AAA batteries (not included). Remove the battery cover and insert the batteries, noting the polarity
marks. A power meter on the top right of the display indicates battery condition.
2) Insert an SD card (“upside down” with metal contacts facing up) in the slot if greater storage is desired. An SD card
icon will appear at the top right corner of the LCD display. You may use SD cards (not MMC cards) up to 2 GB capacity.
If an SD card that has not been formatted for the “FAT” file system is inserted, the display will indicate “C2” (Fig.
1) (most new cards are pre-formatted and ready to use). To format the card, press SNAP once. The display will show
a blinking “Delete All Photos” icon (see “Special Functions”). Press the SNAP button once more to format the card.
Note that this will erase all files-be sure to backup your photos before re-using an old card. If no card
is inserted, the camera will store photos in its 6MB internal memory. When the internal or card memory is full, and
can hold no more photos, the display will indicate “FUL.”
3) Press and release the MODE (Power) button to turn on the camera. The camera will turn off automatically after about two minutes
if no buttons are pressed. To turn the camera off manually, press and hold the MODE button until the display goes out. Note: when the
camera is connected to a computer via the supplied USB cable, the camera will power on automatically, and draw its power from the computer
with no battery drain.
4) Hold the ImageView steady and press SNAP to take a picture. The camera focus is preset to take sharp photos of subjects 50 feet or
farther away. The center focus knob affects only the view through the binoculars.
Special Functions/Features
There are five special functions or features that can be accessed by:
1) Pressing the MODE button one or more times after the camera has been turned on to select the function, then:
Basic Setup