Filter
Top Products
24
Assembly
Step 21 Install Pulleys
Parts:
• Pulley Components (Box 3)
Tools:
• Screwdriver
NOTE: Remove and discard the hex nut to
disassemble the Pulley components.
21-1
Place a Spring Cap over a threaded hole in a
Stabilizer and screw the Hook Bolt into the
hole ONLY about three turns. (Figure A)
21-2
Place the Spring down over the Hook Bolt.
Compress the Spring and hook the Eyelet
under the Pulley to the Hook Bolt. (Figure B)
21-3
Place a screwdriver through the Spring and
Hook Bolt on the Pulleys and tightly screw
them into the Stabilizers. (Figure C)
NOTE: Place the pulleys with the
pre-installed cable closest to the main frame.
Screwdriver
Pulley
Spring
Hook Bolt
Spring Cap
Hook Bolt
Spring Cap
Pulley
Spring
Eyelet
Hook Bolt
Figure A
Figure B
Figure C
Hex Nut (discard)