Incorrect installation of the aerobar could cause you to lose control
and fall from your bicycle. If you are not familiar with the installa-
tion of aerobars, have your dealer install them.
Before installing your aerobar, read the Safety information.
Note to Dealers: If you install this product
for the consumer, please provide him or her
with this owner’s manual after installation
of the aerobar.
Some lightweight aluminum or carbon ber handlebars are
not compatible with aerobar assemblies; refer to the handlebar
manufacturer's installation instructions.
This aerobar is designed to t handlebars with either a 26.0 mm or
31.8 mm stem clamp diameter using the following parts:
• For a 26.0 mm handlebar, use the four shims (two each, E
and F, Figure 2) included with this aerobar assembly.
• For a 31.8 mm handlebar, no shims are required.
• 3, 4, and 5 mm allen wrenches
• Torque wrench
The following letter references (A, B, C, etc.) are for Figure 2.
1. Determine the desired aerobar width.
If needed, unwrap the top section of
handlebar tape to attain the desired width.