Filter
Top Products
9
STEP 4 ASSEMBLE PEC DEC STATION
17
16
17R
17R
14
14
19
19
13
17L
93
92
65
65
65
32
72
76
76
91
93
73
89
89
86
93
40
72
90
90
90
87
31
33
34
33
56
56
59
59
86
89
86
Attach PEC DEC SUPPORT(13) and PEC DEC PULLEY BRACKET(12) to PEC DEC
UPRIGHT(2) using two 1/2" X 4" HEX HEAD BOLT(72) and two 1/2" NYLON NUT(86).
Insert four 3/4" BUSHINGS(65) into PEC DEC SUPPORT(13).
Slide ADJ. CAM(14) onto the axle of RIGHT PEC DEC ARM BRACKET(16). Then thread
the axle of RIGHT PEC DEC ARM BRACKET(16) through the hole on PEC DEC
SUPPORT(13) and attach using 1/2" WASHER(89), 1/2" SPRING WASHER(92) and 1/2"
NYLON NUT(86).
Tighten NYLON NUT(86) and back off approximately 1/2 tum so that arm moves freely.
Repeat the same process to LEFT PEC DEC SET(17L).
Be certain the two ADJ. CAMS(14) are evenly seated on PEC DEC SUPPORT(13) and
two PEC DEC ARMS(17) are WORKING SMOOTHLY before tighten with 1/2" WASHER
(89), 1/2" SPRING WASHER(92) and 1/2" NYLON NUT(86).
Attach PEC DEC SEAT BAR(19) and CONNECTOR PLATE(11) to PEC DEC UPRIGHT
(2) using two 3/8" X 4" HEX HEAD BOLT(76), four 3/8" WASHER(90) and two 3/8"
NYLON NUT(87).