Filter
Top Products
Handlebar Assembly
1. (a.) Locate the display console assembly, the right and left side handles and the four allen
head screws from your hardware bag. (Keep these items within reach as you assemble the
display console and handlebars.) Connect the two connectors on the right side of the console
with the connectors coming up from the handlebar support post. Push the extra wire into the
support post and rest the display console on each support post.
(b.) Now slide the right side handlebar into the console assembly (see illustration b) and align
the two holes with the holes in the display console assembly. Hand tighten the two allen head
screws into the support post. Perform the same step on the left side of the handlebars.
(c.) Once all four screws are tightened by hand, use the 5 mm allen wrench to tighten all
four screws.
2. Push on the plastic covers that go over the handlebar joint as shown in the picture.
9
c
a b
Push on
Plastic Cover