Filter
Top Products
CHANGING THE OIL
1.
Remove the “Screw Plug” located at the bottom of the engine and let the oil drain into an
approved collection container. DO NOT PERFORM THIS PROCEDURE WHILE THE ENGINE IS
HOT. SERIOUS BURNS COULD RESULT FROM CONTACT WITH HOT OIL.
2.
Dispose of the used oil properly. For proper disposal procedures, contact your local oil
recycling center.
3.
Clean and replace the “Screw Plug” tighly.
4.
Rell the engine with the proper amount of oil and recheck the amount of oil in the
engine by using the oil gauge plug.
Screw plug for oil draining
CHECKUP OF SPARK PLUG
1.
Remove the cap of spark plug and screw o the spark
plug using the plug wrench.
2.
Clean the spark plug all around or replace it if it is
corroded or there is too much deposit on it.
3.
Regulate the gap of the spark plug to .7mm - .79mm
(.028”-.031”).
3.
The spark plug of the designated type should be used.
The applicable type of spark plug:
13
INSPEC TION AND MAINTENANCE
.7mm - .79mm
(.028” - .031”)
Autolite-255, AC-CS45,
Champion-CJ11,NGK-BM6A,
Bosch-WS8E