Accusplit AE790M500 Watch User Manual


 
Lap Time & Speed Recall
Similar to the Chrono Recall mode, during speed measurement or Stop state, you can press [RECALL] to
recall the speed/lap memories. The Mode message will be shown for one to two seconds as the Mode
message display is displayed.
The Speed and Lap time will be displayed on the upper and the middle lines. The lower line shows the current
time counting. During Data recall, the fastest speed will be reviewed first, then the slowest speed and average
speed.
Further presses of [RECALL] will retrieve the memories in ascending order or reverse order depending on
whether the speed measurement is stopped or under operation respectively. During Recall, the "Recall"
indicator is ON.
(Note: Speed mode and Chrono mode will not run simultaneously. When Chrono mode is active,
Speed mode should be in reset state and vice versa.)
RECALL
18