Accusplit AE790M500 Watch User Manual


 
Under CS operation mode, the timer, after counting down to 0:00'00", will stay at 0:00'00"0 until you press
[RESET] to reload the timer value.
Under CU operation mode, the timer, after counting down to 0:00'00"0, will count up and stop at 19:59'59"9.
How to set the timer
Press and hold [RECALL] for 2 seconds to activate timer setting. Timer setting starts with second digits,
which are shown blinking. You can press [START] to advance the flashing digits. Or you can press [RESET]
to select other digits. The setting is in sequence of second, minute, hour and timer operating mode (CR, CS
and CU).
NOTE: You can only set Hour, Minute and Seconds. The 1/10 second cannot be set.
Press and hold [RECALL] for 2 seconds.
Timer setting starts with second
digits.
Press [RESET] to move to minute
digits.
Press [RESET] further to go to
hour digits. Hour digits can be
adjusted from 0 to 19.
Press [RESET] again to adjust the
operating mode. Press [START]
to switch the operating modes
among CR, CS and CU.
At the end of setting, press [RECALL] or [MODE] to leave setting mode.
0: 00' 00" 0
CR 0: 00' 00" 0
A 12 : 58' 55
{000}
0: 00' 00" 0
CR 0: 00' 00" 0
A 12 : 58' 57
{000}
0: 00' 00" 0
CR 0: 00' 00" 0
A 12 : 59' 02
{000}
0: 00' 00" 0
CR 0: 00' 00" 0
A 12 : 59' 11
{000}
13