29
AUTO SETUP
PREPARATION
For Equalizing, press k / n to select:
Skip To skip the selected item and perform no
adjustments.
Check: Natural To average out the frequency response of all
speakers with higher frequencies being less
emphasized. Recommended if the “Flat”
setting sounds a little harsh.
Check: Flat To average the frequency response of all
speakers. Recommended if all of your
speakers are of similar quality.
Check: Front To adjust the frequency response of each
speaker in accordance with the sound of
your front speakers. Recommended if your
front speakers are of much higher quality
than your other speakers.
7 Once you have selected the desired setting,
press l to move back to Setup Menu.
8 Press n to select Setup Type, then select:
Auto To automatically perform the entire
auto setup procedure.
Step To pause for confirmation between
each check in the auto setup procedure.
y
This menu item is also available in the front panel display
system options menu (see page 87).
9 Press n to select Start, then press ENTER.
Loud test tones are output from each speaker and
“Measuring” appears during the auto setup
procedure.
y
• To stop the auto setup procedure, press one of the cursor
buttons (
k / n / l / h) or ENTER. In the pause mode,
press k to retry the procedure,
l to cancel auto setup.
• If an error message appears during testing, refer to
“Troubleshooting for the auto setup procedure” on
page 31, and after carrying out the remedy, retry the auto
setup procedure.
• This menu item is also available in the front panel display
system options menu (see page 87).
Setup Menu
Setup Type
Start
Wiring
Distance
Size
Information
Setup Type
Start
Auto
Step
Setup Menu
Information
Start:ENTERStart
Setup Type
Setup Menu
