Commands and Queries Reference Alphabetical reference
RIPL? return the current programmed output ripple for the Power Module.
The result is two decimal numbers: the first being the level (0t o 2)
and the second being the frequency (1 to 7).
Syntax: RIPL?
Parameters none
Category Settings Type: Sequential
ROM? return a string identifying the XMP 2600. The result is “XMP 2600
x.xx dd/mm/yy” where: x.xx is the firmware revision code and
dd/mm/yy is the firmware date code.
Syntax ROM?
Parameters none
Category System Type: Sequential
SEQ start / stop sequence program execution.
Syntax SEQ <int>
Parameters a value of “0” will stop and a value of “1” will start
the Sequence Program.
Category System Type: Sequential
SEQ? return the current state of the Sequence Program. The result is a single
decimal number of value “0” if the program is not running. If the
program is running then the result will have two elements: the first is
the number (1 to 99) of the step being executed and the second is the
amount of time left until the step’s operation will be performed
(h:mm:ss).
Syntax SEQ?
Parameters none
Category System Type: Sequential
SEQCLR clear all Sequence Program Steps (only if program is not running).
Syntax SEQCLR
Parameters none
Category System Type: Sequential
XMP 2600 Programming Manual
rev. 1.1 59
