11
Storing Pauses in Memory
• To insert a pause in a phone number,
press REDIAL/PAUSE. The pause is
2 seconds in length. For longer
pauses, press REDIAL/PAUSE two or
more times. Each additional press
adds an additional 2 seconds pause.
• If your phone is connected to a PBX
you can store the PBX access number
and a pause before the phone number.
For example, to store 9-PAUSE-555-
1234 in memory location 8 do the
following:
• Press MEM/PROG.
• Press 8.
• Press 9.
• Press REDIAL/PAUSE.
• Dial 555-1234.
• Press MEM/PROG.
Using Redial
• To redial the last number you called,
press PHONE then press REDIAL/
PAUSE. The phone will automatically
dial the number.
Storing a Redial Number into Speed
Dial
• To store the last number you dialed as
a Speed Dial number, press MEM/
PROG, a location number (0-9),
REDIAL/PAUSE, MEM/PROG.
The Page Feature
• From the Base Unit, press PAGE to
signal the person at the Handset.
• To end the page at the Base, press
PAGE again.
• To end the page at the Handset, press
OFF.
• If the Handset is in use (off-hook)
when PAGE is pressed on the base
Unit, the Handset will not emit one
page alert. If the Handset is not in use
(on-hook), the page alert will continue
for approximately 60 seconds.
• This feature is useful in locating a
misplaced Handset.
Operating Instructions
