A SERVICE OF

logo

Replacement Procedures
Satellite U400/Satellite Pro U400/PORTEGE M800 Maintenance Manual 31
Installing the Top assembly
The following describes the procedure of installing the cover assembly.
1. Install the Top assembly to the base assembly.
NOTE: Be careful not to catch the cables between cover assembly and base assembly.
2. Connect the touch pad flat cable to the connector on the system board.
3. Secure the cover assembly with the following screws from the back and bottom of
computer.
M2.0×5.0 FLAT BIND screw Back x9
M2.5×8 FLAT BIND screw Back x4
4. Free the cable from cable-drain when through the antenna cable to PCB hole.