26
Adjustment tips for the operating menu
Adjusting the microphone sensitivity –
“ATTEN”
Via the “ATTEN” menu, you can adjust the radio microphone’s sensitivity
by changing its input attenuation.
Adjusting the low-cut frequency –
“LOWCUT”
To reduce unwanted low-frequency noise such as engine, wind and rumble
noise, you can activate a low-cut filter. The low-cut frequency can be set to
190 Hz or 120 Hz.
If you do not want to reduce low-frequency signal portions, select the
setting “FLAT”.
Selecting the standard display – “VIEW”
Via the “VIEW” menu, you can select one of the following standard
displays:
The selected standard display is shown
•after switch-on,
• after the menu settings have been displayed in display mode.
The input attenuation is correctly adjusted
when the level display for audio signal “AF”
shows full deflection ቪ only during the
loudest passages. The input attenuation can
be adjusted in 1-dB steps from – 40 dB to 0 dB.
The bargraph has a resolution of approx. 3 dB per segment with a
display range of 45 dB.
Transmission
frequency “FREQ
Channel “CHAN”Name “NAME”
dB
AF
RF
ቪ
CH
MHz
RF
CH
CH
RF
RF
