CONDENSERMICROPHONE
ACCESSORIES
MICROPHONE-CRAVATE
APINCE
MKH 124, MKH 125T, MKH 126 P48
Batteryadapters
Batteryadapter MZA 15
Can be connected into the micro-
phone line at any point. Fitted with
9 mercury cells Mallory RM 625, it
provides a continuous operation
for 50 to 60 hours. The mercury
cells can be purchased in allshops
with cater for the hard of hearing.
To prevent an unnecessary dis-
charge ofthe batteries, the battery
adapter should be unscrewed
from the microphone when itis not
in use.
Dimensions in mm: 22 0 x 132.
Battery adapter MZA 15-U
Fitted with Cannon connector
XLR-3-11 C and plug XLR-3-12 C
for use with the MKH-U types.
Batteries as in MZA 15.
Special feature: Ifthe plug and
connector are connected to-
gether the battery condition is
indicated by C!built-in signal diode.
T0 prevent an unnecessary dis-
charge of the batteries the battery
adapter should be unscrewed
from the microphone when it isnot
in use.
Dimensions in mm: 220 x 152.
Power supplies
Power unit MZN 16T and T-U
For simultaneous powering of two
microphones. Connection to
220 volt or 110 volt supplies. The
unit can be included inthe micro-
phone cable atany point. Model
T-U with Cannon connectors.
Dimensions in mm:
168 x 120 x 50.
AC Power Supply MZN 16 P48
and MZN 16 P 48-U
The power supply is designed for
48 Vphantom powering, according
to engineering standard DIN
45596. Model MZN 16 P 48 is
used with condenser microphones
of the MKH . . . P48 type, while
model MZN 16P48-U isequipped
with XLR connector for condenser
microphones of the
MKH ...P48-U type. Both models
will supply power to !wo micro-
phon es simultaneously.
Dimensions in mm:
168 x 120 x 50.
Auxiliary units
Introduction
Transistor amplifier KAT 15-2
For the connection of condenser
microphones, or symmetricallow
impedance dynamic micro-
phones, to the line and accessory
inputs respectively, ofthe Nagra 111
or Nagra IV.Selected functions:
T = condenser microphones
N = dynamic microphones
A switchable footfall filter is in-
cluded.
Dimensions in mm: 85 x 40 x 25.
L'element micro MK 12 est un micro-cravate apince electrostatique HF,
avec un diaphragme de 6 mm de diametre. Conformement ason utili-
sation,le micro est un capteur de pression, adirectivite omnidirectionnelle
et pour cette raison insensible aux bruits d'origine mecanique. Le micro
complet est compose de deux elements: un element micro et un element
haute-frequence. L'element micro MK 12 est le meme pour le MH 124,
MH 125 T, MH 126 P 48 ou I'emetteur de studio SK 1007. Un cordon
prolongateur MZV 125 entre I'element micro et I'element HF est
disponible en accessoires.
Notices techniques
Roll-oft-filter MZF 15
The roll-olf-filter MZF 15 should
be included only between supply
voltage source and amplifier input.
Frequency reduction
at 50 Hz approx. 6 dB
at 25 Hz ~ 15dB
Dimensions in mm: 220 x 152.
Cables
Connecting cable KA 1and KA 7
Tripie conductor screened cable.
Fitted with 3 pin connectors
according to DIN 41 524.
KA 1: 1.5 m long, KA 7: 7.5 m long.
Connecting cable KA 7-1
For use with allSennheiser micro-
phones with the sulfix U. The
KA 7-1 is fitted on one end with a
cannon female connector, the
other end isfree for the connection
of the necessary plug. The cable
is 7.5 meters long.
Montage haute-frequence
Contrairement au montage basse frequence, la capsule d'un micro
electrostatique a haute frequence presente une faible impedance. A la
place de latension de polarisation relativementeJevee, la capsule n'est
soumise qu'a une faible tension d'environ 10 volts, foumie par unoscilla-
teur (8 MHz) afaible bruit de fond. Lafaible impedance du systeme apour
consequence un bruit de fond tres faible et une haute fiabilite
des microphones.
Connecting cable KAM 1-5
For the connection of series 6
microphones to the "Mikroport"
transmitters SK 1007,
SK 1008 and the SER 1.The
microphones are powered from
the transmitter.
KAM 1-5: 1 m long.
Types
MK12 + MH124 = MKH 124
Le MKH 124 est prevu pour le raccordement direct aI'emetteur Microport
SK 1008-3. L'alimentation est assuree par I'emetteur.
Further general accessories e. g. tripods, booms, table stands etc. can
be found in our catalogue "Senn heiser-revue".
MK 12 + MH 125T = MKH 125T
Le MKH 125Test prevu pour le raccordement ades cäbles alimentes par
conducteurs de modulation. C'est Sennheiser qui aintroduit I'alimenta-
16
17
