SR3 to SR5 banks contain several groups. To turn off a group,
press the group number; the group number disappears. To turn
the group back on, press the group number again.
2. Adjust the Squelch. After the set delay, the scanner starts
searching. When the scanner nds an active frequency, it stops
searching.
3. To pause while searching, press PSE. The scanner stops
searching and *** PAUSED *** appears. To resume, press PSE
again.
4. If the scanner stops on an unwanted frequency, you can press
L/OUT to lock out the frequency.
In the SR6 Railraod and SR7 Limit search bands, press FUNC then
or to start searching up from the lowest or down from the
highest frequency.
To search banks SR0-SR2:
1. Press SRCH repeatedly to select SR0, SR1, or SR2.
2. To search the entire band, press FUNC then SRCH. “MAN”
(Manual select) or “SRCH” (searches through the band) appears.
The scanner starts searching and “SRCH” appears on the display.
When the scanner nds an active frequency, it stops searching.
Press FUNC then SRCH again to return to the previous mode.
3. To select a channel while “MAN” appears on the display, press a
channel number or use or .
4. Adjust the Squelch.
5. If the scanner stops on an unwanted frequency, you can press
L/OUT to lock out the frequency. For more information, see
Locking Out Frequencies....
6. To pause while searching, press PSE. The scanner stops
searching and *** PAUSED *** appears. To resume, press PSE
again.
