A SERVICE OF

logo

Open as PDF
next previous
Page22
7014-179D
December 16, 2011
R
CB 1200 Pellet Stove
1. A12voltACthermostatisrequiredtooperatethispellet
appliance.Youmayusetheincludedwallmountthermo-
statorpurchaseanoptionalprogrammablethermostat
orremotecontrol.Itisequippedwithanadjustable
heatanticipator.Thecurrentratingis.05amps.The
anticipatorneedstobeadjustedtothelowestsetting
available.
2. Whenmountingathermostatonawall,besuretofollow
yourthermostatinstallationinstructionscarefully.
NOTE: Thermostat must be mounted level for
accurate readings. The thermostat should be
mounted on an inside wall and not in direct line
with the appliance convection air.
NOTE: If the thermostat is located too close to the
appliance, you may need to set the temperature
setting slightly higher to maintain the desired
temperature in your home.
3. Thereisa4screwterminalblocklocatedontheback
lowerleftcornerofthestovedirectlyabovethepower
cordinlet.Thecenter2screwsareforthethermostat
wires.
J. Thermostat Installation
Figure 22.1
Shockhazard.
• DoNOTremovegroundingprongfromplug.
• Plugdirectlyintoproperlygrounded3prong
receptacle.
• Routecordawayfromappliance.
•
DoNOTroutecordunderorinfrontofappli-
ance.
CAUTION
Power Outlet
Terminal Block.
Center 2 screws for
Thermostat Wires
I. Door Installation
To install door:
1.Carefullyremovedoorfrompackaging.
2.Lineuphingeswithhingepinsonappliancebody,andslide
doordownuntilitsitssecurelyonpins.
Figure 22.1
.
3.
I
fdoorisplated,besuretocleanallplatedsurfacesand
glasswithaglasscleanertoensurealloilsareremoved
beforeyourrstburn.
4.Removealllabelsfromglassbeforeburningappliance.
To adjust latches:
1.Closedoorsecurely.
2.Placerod in sloton the bracketon the doorand close
latch.
3.Latch must close tightly enough to ensure an airtight
sealbetweenthedoorandthebodyoftheappliance.To
increasetensiononthelatch,turntherodclockwiseafew
turns,thenattempttoclosethelatch,untilitissnug.Donot
overtighten;youshouldbeabletoclosethelatchwithyour
hand.
Figure 22.2
.
4.Afteradjustingthelatch,placeaPhillipsheadscrewdriver
intheendoftherod,andtightenthenutwithawrench.
Thiswillmaintainthecorrecttensionontherodandlatch.
Hinge
Hinge Pin
Rod and nut
Rod and nut
Figure 22.2
Figure 22.3