Switching to 16:9 wide screen picture
When you play a cassette that has been recorded in 16:9 wide
screen format, you can switch this function ’ON’. The TV set
will now automatically switch to wide screen. This only works
if you have connected the TV set and the video recorder with a
scart cable and if your TV set is suitable for wide screen.
a Switch on the TV set and select the programme number
for the video recorder.
b Press the MENU button. The main menu will appear.
c Select the line ’SPECIAL SETTINGS’ with the menu
buttons P = or P ; and confirm with the P button.
d If you have a wide-screen TV set, select ’ON’ in line
’16:9 WIDE SCREEN’. If not, select ’OFF’ with the menu
buttons P or Q .
e Confirm with the OK button.
f To end, press the MENU button.
Switching the remote control command
If you have two video recorders with the same remote control,
you can change the commands of the remote control for one
of the video recorders to avoid sending the message to the
wrong recorder.
a Switch on the TV set and select the programme number
for the video recorder.
b Press the MENU button. The main menu will appear.
c Select the line ’SPECIAL SETTINGS’ with the menu
buttons P = or P ; and confirm with the P button.
d Select the line ’VCR 1 OR 2’ with the menu buttons
P = or P ; .
e Select ’VCR 1’ or ’VCR 2’ with the menu buttons Q or
P .
f Confirm with the OK button.
g On the remote control, press the SELECT button and but-
ton 2 at the same time to switch the remote control to
’VCR 2’.
DIf you want to switch back to ’VCR 1’, press the SELECT
button and button 1 at the same time.
h Confirm with the OK button.
DIf the menu does not disappear, this means the video
recorder didn’t recognize the remote control command.
Repeat step g .
DIf you change the batteries in the remote control, it will
switch back to ’VCR 1’.
DIf you have entered the wrong remote control command
and you press a button for a few seconds, a message will
appear on the TV screen or ’VCR 1’ will appear on the
video recorder display.
Continuous play
a Switch on the TV set and select the programme number
for the video recorder.
b Press the MENU button. The main menu will appear.
c Select the line ’SPECIAL SETTINGS’ with the menu
buttons P = or P ; . Confirm with the P button.
d Select the line ’REPEAT PLAY’ with the menu buttons
P = or P ; .
e Select ’ON’ with the menu buttons Q or P .
f Confirm with the OK button.
g Press the MENU button.
h Put in a cassette and press PLAY G .
When the video recorder reaches the end of the tape or
the end of the recording, it will rewind and start again.
16
