DNS2
Description Specifies the IP address of the secondary DNS server.
Note
• This setting is available only when [Connection Mode] is set
to [Static].
Value Range Max. 15 characters ("n.n.n.n" [n=0–255], except "0.0.0.0",
"255.255.255.255", "127.0.0.1", etc.)
Default Value Not stored.
Phone User Interface
Reference
Configuring Settings from the Base Unit (KX-TGP550 only)/Handset
(Page 15)
Configuration File Reference USER_DNS2_ADDR (Page 153)
3.4.2 Ethernet Port Settings
This screen allows you to change the connection mode of the Ethernet ports and the VLAN settings.
Note
• When you change the settings on this screen and click [Save], after the message "Complete" has been
displayed, the base unit will restart automatically with the new settings applied. If a unit is on a call
when "Complete" has been displayed, the base unit will restart after the unit returns to idle.
• Incorrect settings may cause a network failure. In such a case, you cannot access the Web user
interface anymore. To access it again, you need to correct the speed/duplex settings (® see
2.1.2 Speed/Duplex Settings) or perform IP Reset (® see 2.1.4 IP Reset) through phone user
interface programming.
3.4.2.1 Link Speed/Duplex Mode
LAN Port
Description Selects the connection mode (link speed and duplex mode) of the LAN
port.
Document Version 2010.03.15 Administrator Guide 65
3.4.2 Ethernet Port Settings
