Mitutoyo qm-data 200 Manual

A SERVICE OF

next previous

No. 99MBA038A

5-2

5.2 Performing AI Measurement

[Purpose of Practice]

To practice measurements utilizing the AI function using the model workpiece. In this

section, line (A), circle (B) and angle (C) are measured successively in the AI measurement

mode.

(C)

(B)

(A)

Fig. 5-2-1

[Operating Procedure]

Table 5-2-1

No. Operation Screen display and remarks

1

Preparing the workpiece

Set the model workpiece on the XY table as shown

below, and focus on it.

–

2

Aligning the part coordinate system

For the aligning procedure, see Section 3.2 “Aligning

Part Coordinate System Using Edges as Reference”.

The explanation for the operations from

step 3 onward assumes that the part

coordinate system has been aligned.