TrainMaster Command Control operations
Tuning your locomotive set’s performance (continued)
Setting the minimum speed
You may use your CAB-1 Remote Controller to set your locomotive’s minimum, or stall, speed.
Perform this procedure on both units simultaneously if you will be running them
together.
1. With both Command reverse unit switches in the RUN position, address your locomotive by
pressing TR and the lash-up ID#.
2. Press SET on the CAB-1 Remote Controller. The headlight will flash.
3. Get your locomotive moving at your desired minimum speed.
4. Press SET again. The locomotive set will stop.
The next time you throttle up, your locomotive set will start at the speed you set. To clear
this setting, press SET twice, holding the button for one second each time. To set the maximum
speed of an individual unit, address the locomotive using ENG and the unique locomotive ID#.
21
Note!
