EN23
RECORDING
+2
FLASH ADJ.
OFF
P
L
A
Y
5S
END
Flash Brightness Adjustment
When a snapshot (੬ pg. 16) is taken in the dark the
camcorder fires the flash (੬ pg. 22) and adjusts the
brightness automatically. You can also adjust the flash
brightness manually. When you find that the snapshots
you took look too bright or too dark, adjust it manually.
1
Set the Power Switch to “ ” or “5S” while pressing
down the Lock Button located on the switch, then
pull out the viewfinder fully or open the LCD monitor
fully.
2
Press MENU/BRIGHT. The Menu Screen appears.
3
Rotate MENU/BRIGHT to select “ ”, and press it.
4
To intensify the flash, rotate MENU/BRIGHT towards
“+”. To weaken the flash, rotate it towards “–”.
Adjustment range: –3 to +3.
5
Press MENU/BRIGHT twice to close the Menu
Screen.
NOTES:
●
When the battery power is low, the “ ” setting cannot
be changed.
●
When you change the subject you are shooting or the
shooting location, set it back to ±0 as described in step 4
and take a snapshot to check the flash brightness. After
doing this adjust to your desired brightness.
Power Switch
Display
Lock Button
Menu Screen
MENU/BRIGHT Dial
