1312
Installation
5
Verify that the vehicle belt is not
twisted, then buckle (
Fig. D
)
.
6 While kneeling on the restraint to push
it firmly into the vehicle backrest, remove
all slack from the vehicle belt.
•
First remove slack from the lap portion of
the vehicle belt, then the shoulder portion
(Fig. E & F).
7 Verify that the vehicle belt is tight and
the child restraint is secure.
Refer to
Figure G
for correct routing of the
lap-shoulder vehicle belt.
IMPORTANT:
Always use the Versa-
Tether for children weighing more than
50 pounds (22.6 kg). See pages 18-19.
Removal
Reverse installation procedure.
E
F
G
Installation
Lap-Shoulder Belt Installation
Long Route
Figure A
illustrates a typical long route lap-
shoulder belt installation.
WARNING:
•
Do not install this restraint using a non-
locking ELR vehicle belt, unless a locking
clip is used. Refer to the vehicle owner's
manual for instructions on correct use of
vehicle belts with child restraints.
1 Insert recline bar into holes on rear of
restraint
(
see page 20
)
.
2 Place the child restraint in a forward
facing position on the vehicle seat.
3
Pull the vehicle belt out and pass it
through the first belt slot, from the front of
the restraint to the rear (
Fig B
).
4
Route the vehicle belt around the
back of the restraint then through the
second belt slot, from the rear of the
restraint to the front
(
Fig. C
)
.
B
A
C
D
