10 PRO-2200 Enclosure PRO22ENC1 & PRO22ENC2Installation Guide
Dimensions
ENC1 ENC2
Height: 13.9" [0.353 m] 13.9" [0.353 m]
Width: 17" [0.4318 m] 18.9" [0.48006 m]
Depth: 9" [0.2286 m] 9" [0.2286 m]
Metal thickness: .05" [1.27 mm]
Color: Autumn White
Installation holes: Four hangers in a rectangular pattern 12.1” [0.30734 m] H x 16"
[0.40640 m] W
Conduit Knockouts
½" [0.0127 m] 2" [0.05080 m]
Back: 9 2
To p: 9 2
Right Side: 2 1
Left Side: 2 1
Power Supply
Use PRO22E1PS or other approved power supply. (See Installation Manual for details).
Maintenance
Oil lock once per year. If battery backup is used, change battery every 2 to 2 1/2 years.
Installation Instructions
1. Measure and install four mounting screws with heads smaller than .4" [0.01016 m]
using proper techniques for the material on which the PRO-2200 is being mounted.
Use a rectangular screw pattern 12.1" [0.30734 m] H x 16" [0.40640 m] W. Leave the
screws exposed approximately 1/2" [0.0127 m].
2. Open the door of the enclosure and place the hanging slots over the mounting screws.
Push the enclosure over the mounting screws and allow the screws to slide into the
slots. Finish tightening the mounting screws to securely hold the enclosure.
3. Run all appropriate wiring to the case. Mark each wire as to the panel, location and
input type. All cable shields should tie to the copper grounding lug found on the
bottom right of the enclosure.
4. Install the required panels into the metal runners. The PRO22E1PS should be placed
in the right most location and installed according to its own instruction manual. The
PRO22IC should be installed next to it as the right-most panel.
5. Wire the readers, input and output connections (see wiring guide at end of manual)
6. CHECK ALL CONNECTIONS PRIOR TO POWERING UP THE ENCLOSURE
AND PANELS.
