F58F COMMERCIAL DUCT MOUNTED ELECTRONIC AIR CLEANER
68-0141—4
8
Location
The styling of the W8600F is designed to blend with the latest
T8600 family of Honeywell Chronotherm® IV Deluxe
Programmable Thermostats. A special mounting template is
included for mounting next to the T8600. The W8600F can
also be mounted at any other convenient location in the living
area or equipment room.
NOTE: The W8600F shares no common electrical
connections with the thermostat.
Table 1. Description of W8600F Function Indicator Panel.
Indicators Condition
ON EAC is powered and system blower is
running.
BATTERY Battery that maintains W8600F memory is
low and needs to be replaced.
SERVICE
EAC prefilter and cells need to be washed
a
.
FAULT • Shorting of collector plates.
• Continuous ionizer or collector plate
arcing.
• Power supply failure.
• Excessive current.
• Major reduction in high voltage.
• EAC prefilter and cells are past SERVICE
level of dirt and need to be washed
immediately.
Call a service technician.
a
The reset button is located on the bottom of W8600F. After
the prefilters and cells are cleaned and reinstalled, press
this button to turn off the SERVICE indicator and reset the
wash frequency timer.
Mounting
The following mounting instructions assume that the W8600F
is mounted next to a T8600 Thermostat. If installing the
monitor at another location, modify the procedure to fit the
installation.
1. Hold the mounting template (included in the bag
assembly) next to the T8600 as shown in Fig. 9.
2. Mark the holes for the screw anchors and the
3-conductor thermostat cable.
3. Remove the template and drill the holes.
4. Remove the W8600F from the base.
Fig. 9. Positioning mounting template.
M11971
THERMOSTAT
WALLPLATE
MOUNTING
TEMPLATE
MOUNTING HOLES
2
WIRING HOLE
5. Position the W8600F base over the holes and install the
anchors and screws. Tighten the screws until the base
is mounted firmly on the wall.
Select Wash Frequency
Use the W8600F DIP switches to program the time between
SERVICE indications. Be sure to select the setting according
to the conditions of the home. Factors to consider include the
duty cycle of the EAC, the number of people and pets, and
activities such as woodworking and other crafts that are being
done in the home.
Refer to Table 2 to select the wash frequency. Set the
W8600F DIP switches to match the selection. See Fig. 10.
The time listed represents actual run time of the EAC, not
calendar days.
Table 2. Wash Frequency Options.
DIP Switch Settings
F1 F2 F3 Wash Frequency (Days)
Off Off Off 10
Off Off On 20
Off On Off 30
Off On On 40
On Off Off 50
On Off On 70
On On Off 100
On On On 180
Fig. 10. Back of W8600F.
M11969
BATTERY
IN HOLDER
DIP SWITCHES
WIRING
TERMINALS (3)
BACK OF W8600F
1
3
4
